Pacific hydrostar 95619 Assembly And Operating Instructions Manual page 4

19. Check for damaged parts
should be carefully checked to determine that it will operate properly and perform its
intended function. Check for alignment and binding of moving parts; any broken parts
or mounting fixtures; and any other condition that may affect proper operation. Any
part that is damaged should be properly repaired or replaced by a qualified techni-
cian. Do not use the tool if any switch does not turn On and Off properly.
20. Guard against electric shock
as a power outlet or extension cord.
21. Replacement parts and accessories
ment parts. Use of any other parts will void the warranty. Only use accessories in-
tended for use with this tool. Approved accessories are available from Harbor Freight
Tools.
22. Do not operate tool if under the influence of alcohol or drugs
labels on prescriptions to determine if your judgment or reflexes are impaired while
taking drugs. If there is any doubt, do not operate the tool.
23. maintenance
larly by a qualified technician.
24. use only Cold Water and/or pressure washer detergent as the active propellant
in this tool. Do not use detergents not designed for pressure washers, caustic mate-
rials, solvents or any flammable materials in this machine. Use of any such material
can cause injury, or damage this tool or personal property.
25. During use, do not allow the high pressure hose to come in contact with any
hot part of the engine or pump. Damage to the hose may occur possibly causing
the hose to burst or leak under high pressure.
26. in case of emergency during use, immediately release the trigger on the spray
handle, then turn the engine off. Do not set the spray handle down without turning
off the engine. Then shut off gas supply to engine. (Refer to engine manufacturer's
manual for fuel shut off procedures.)
27. avoid tipping over the pressure washer.
surface.
28. never leave the engine running for more than 3 minutes without spraying.
leave the pressure washer unattended while the engine is running.
29. use tools with both hands when required.
maintain tool stability and keeps hands away from operating parts of the tool.
30. People with pacemakers should consult their physician(s) before use.
magnetic fields in close proximity to heart pacemaker could cause pacemaker inter-
ference or pacemaker failure. Caution is necessary when near engine's magneto or
recoil starter.
31. never touch the water jet.
Injury may result.
SKU 95619 For technical questions please call 1-800-444-3353
. Before using any tool, any part that appears damaged
. Prevent water spray into any electrical source such
. For your safety, service and maintenance should be performed regu-
Never touch the water jet or point it at people or animals.
. When servicing, use only identical replace-
Only use on a level solid and stable
This tool requires the use of two hands to
. Read warning
Do not
Electro-
Page 4