Quick Setup - InfoPrint 5504-R40 User Manual

Chapter 3

QUICK SETUP

QUICK SETUP
QUICK
SETUP
(from page 82)
Print Print
Intensity Speed
-3* 6 ips*
-15 to 15 1 ips to 10 ips
Label
9
Width
2, 4
4.1, 6.6, or 8.5 inches*
4
00.1 to 8.5 inches
Auto Calibrate Validator
Funct.
Run Calibrate Enable*
Disable
11
SMT: Status PAA: Select
Tool
Disable* None*
Enable CST-1
CST-2
NOTES:
* = Factory Default
1
Maximum value depends on the printer model width (4, 6, or 8 inches) and printhead (203 or 300 dpi).
2
You can change the unit value from inches to millimeters under Units (in MEDIA CONTROL) when Admin User is
enabled.
3
Based on the current value setting for the Label Length (in QUICK SETUP), up to a maximum of 12.80 inches.
4
Maximum value depends on the width of the printer model (see Appendix A, "Specifications").
5
Maximum value depends on model width and size of DRAM installed (see Appendix A, "Specifications").
6
Gap/Mark Sensor and Paper Out Sensor work in conjunction, as shown in Table 6 on page 127. If you change the
Gap/Mark Sensor or Paper Out Sensor, you must recalibrate the media.
7
This menu appears only if a validator is installed.
8
This menu will not appear on Direct Thermal only printers.
9
Resolution changes based on "Label Resolution" menu under MEDIA CONTROL if Small Label Printer is installed.
10
xxx represents the emulation name selected in the Active IGP Emul menu.
11
This menu appears only if RFID is installed and there is no CST bundle in the Flash File System.
12
This menu appears only if RFID is not installed and there is a CST bundle in the Flash File System.
94
Print Media
8
Mode Handling
Transfer* Tear-Off Strip*
1
Direct Tear-Off
Peel-Off
Cut
Continuous
Ver Image Hor Image
Shift Shift
2
0.00 inches 0.00 inches*
3
-1.00 to X inches -1.00 to 1.00 inches
Active IGP
7
Emul Diagnostics
PGL* Disable*
ZGL Enable
TGL
IGL
STGL
DGL
IEGL
MGL
VGL
12
Paper Feed
Shift
2
0.00 inches* 4 or 6 inches*
3
-1.00 to X inches 00.1 to 99.0 inches
Orientation
2
Portrait*
Landscape
Inv. Portrait
Inv. Landscape
xxx Save Config.
10
1* Factory*
1-8 1-8
Label
9
Length
2, 4
5
Gap/Mark
6
Sensor
Disable
Mark
Gap
Advanced Gap*
Advanced Notch
Power-Up
Config.