Main Menu - InfoPrint 5504-R40 User Manual

Chapter 3

Main Menu

Main Menu
QUICK
SETUP
(page 94)
Refer to the RFID
Print Intensity
Print Speed
Labeling Reference
4
Print Mode
Manual .
Media Handling
Paper Feed Shift
Label Length
Label Width
Ver Image Shift
Hor Image Shift
Orientation
1
Gap/Mark Sensor
Auto Calibrate
3
Validator Funct.
Active IGP Emul
7
xxx Diagnostics
Save Config.
Power-Up Config.
5
SMT: Status
6
PAA: Select Tool
Press to select the next main menu.
. .
.
Press ↓ or ↑ to move within each main menu.
−
Press + or to cycle through each possible option or value.
NOTES:
Italicized items are available only when you enable Admin User (under PRINTER CONTROL).
1
Gap/Mark Sensor and Paper Out Sensor work in conjunction, as shown in Table 6 on page 127. If you
change the Gap/Mark Sensor or Paper Out Sensor, you must recalibrate the media.
2
This menu appears only if an RFID encoder is installed.
3
This menu appears only if a Validator is installed.
4
This menu will not appear on Direct Thermal only printers.
5
This menu appears only if RFID is installed and there is no CST bundle in the Flash File System.
6
This menu appears only if RFID is not installed and there is a CST bundle in the Flash File System.
7
xxx represents the emulation name selected in the Active IGP Emul menu.
82
RFID VALIDATOR
2
CONTROL
Refer to the Online
Data Validator
User's Manual
3
CONFIG.
CONTROL
(page 103)
Save Config.
Load Config.
Print Config.
Delete Config.
Power-Up Config.
Protect Configs.
Name Config 1
Name Config 2
Name Config 3
Name Config 4
Name Config 5
Name Config 6
Name Config 7
Name Config 8
Reset Cfg Names
Auto Save