Admin User
•
•
The factory default is Disable.
EMULATIONS
Overview
This section covers the following emulations:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
You can select emulation default parameters directly from the control panel, or
by control codes as explained in the appropriate Programmer's Reference
Manual.
IMPORTANT
BEFORE you reconfigure an emulation, print a configuration sheet to
see all current settings.
Disable. When disabled this function does not permit access to
submenus which would not normally be changed by a typical user.
Enable. When enabled, this function permits access to submenus which
would not normally be changed by a typical user.
Coax (page 153)
Twinax (page 156)
SPC Coax (page 158)
SPC Twinax (page 159)
IPDS (page 160)
TN3270 (page 164)
TN5250 (page 166)
PGL (page 168)
VGL (page 170)
ZGL (Refer to the ZGL Programmer's Reference Manual. )
TGL (Refer to the TGL Programmer's Reference Manual. )
IGL (Refer to the IGL Programmer's Reference Manual.)
STGL (Refer to the STGL Programmer's Reference Manual.)
DGL (Refer to the DGL Programmer's Reference Manual.)
MGL (Refer to the MGL Programmer's Reference Manual.)
IEGL (Refer to the IEGL Programmer's Reference Manual.)
P-Series (page 172)
P-Series XQ (page 174)
Serial Matrix (page 176)
Proprinter XL (page 178)
Epson FX (page 180)
Overview
149