Adjusting Seat Height - Invacare Lynx L-4 Owner's Operator And Maintenance Manual

Adjusting Seat Height

NOTE: For this procedure, refer to FIGURE 7.2.
1. Remove the seat. Refer to Removing/Installing the Seat on page 30.
2. Loosen the knob on the frame tube.
3. Remove the locking pin that secures the seat post to the frame tube.
4. Align the frame tube mounting hole with one of three seat post mounting holes to
achieve desired seat height.
Make sure the detent balls of the locking pin are fully released beyond the outer
edge of the frame tube before operating the scooter. Otherwise, injury and/or
damage may result.
Keep detent balls clean.
5. Insert the locking pin through the frame tube and seat post. Ensure the detent balls
(not shown) of the locking pin are beyond the outer edge of the frame tube and the pin
secures the frame tube to the seat post.
6. Tighten the knob until the seat post does not move around inside of the frame tube.
7. Install the seat. Refer to Removing/Installing the Seat on page 30.
NOTE: Knob removed
for clarity. The knob
does not have to be
removed to perform
this procedure.
Knob
Part No. 1143205
WARNING
Locking Pin
FIGURE 7.2 Adjusting Seat Height
31
SECTION 7—SEAT AND ARMS
Seat Post
Mounting
Holes
Frame Tube
Frame Tube Mounting Hole
Lynx™L-3 & Lynx L-4