Removing/Installing The Battery Box - Invacare Lynx L-4 Owner's Operator And Maintenance Manual

SECTION 10—BATTERIES
NOTE: Charge batteries daily. DO NOT allow batteries to completely discharge.
NOTE: Invacare recommends that both batteries be replaced if one battery is defective.
12 Volt, 12 Amp-

Removing/Installing the Battery Box

NOTE: For this procedure, refer to FIGURE 10.2.
Removing
1. Turn power off and remove the key from the ignition.
2. Remove the seat. Refer to Removing/Installing the Seat on page 30.
3. Hold the battery box handle and lift the battery box up and away from the scooter
(Detail "A").
Installing
1. Turn power off and remove the key from the ignition.
2. Remove the seat. Refer to Removing/Installing the Seat on page 30.
3. Holding the battery box handle, carefully lower the battery box on to the battery tray
in the scooter (Detail "B").
4. Press down the battery box to engage the connector on the battery box (not shown)
with the connector on the scooter base (Detail "B").
5. Reinstall the seat. Refer to Removing/Installing the Seat on page 30.
Lynx™L-3 & Lynx L-4
Hour (12AH)
Battery
FIGURE 10.1 Recommended Battery Type
38
Part No. 1143205