Adjusting Seat Height; Activating/Deactivating The Audible Signals - Invacare Leo User Manual

Invacare® Leo
3. Release the tiller adjustment lever to lock the tiller into the
desired position.
4. Gently push/pull against tiller to ensure that the tiller is securely
locked.

5.8 Adjusting Seat Height

Tools:
•
2 x 17 mm open-ended spanner
A
B
Take note of position and orientation of mounting hardware
before removing.
1. Remove the seat A. Refer to 5.5 Removing/Installing the seat,
page 20.
2. Pull up to remove the top shroud B and expose the seat post C
and mounting hardware.
Remove the mounting screw D, two washers E, locknut F and
3.
cap G that secure the seat post to the frame tube H.
4. Align the frame tube mounting hole with one of five seat post
mounting holes I to achieve desired seat height.
5. Install one washer onto the mounting screw.
6. Insert the mounting screw through the frame tube and seat post.
22
C
E
F
E
G
H
7. Install the remaining washer onto the mounting screw.
8. Install the locknut and cap onto the mounting screw to secure
the seat post to the frame tube.
9. Install the top shroud.
10. Install the seat. Refer to 5.5 Removing/Installing the seat, page 20.

5.9 Activating/Deactivating the Audible Signals

The scooter system emits an audible signal in the following situations:
•
Low Battery Capacity
•
Direction Indicators in Use
•
Hazard Lamps in Use
The audible signals can be activated or deactivated by pressing the
buttons on the control panel A in a particular keystroke combination.
1 2 3
A
D
C
1. Turn the key to the Off position.
2. Press and hold the buttons on the control panel in the keystroke
combination shown in the table Audible Signal.
3. Turn the key to the On position.
4. Wait two seconds until the appropriate blink code is displayed
on the battery charge display B, then release the buttons.
4 5 6 7
B
1506942-P