Rotate Blower - Optional - Jenn-Air W10298937A Installation Instructions Manual

IMPORTANT: The following additional steps must be performed if
the product is being installed in peninsula or island cabinetry.
The blower exhaust scroll is shipped from the factory set to
exhaust straight out the back of the cabinet through an exterior
wall.
D
C
A
E
A. Blower exhaust scroll
B. Plenum
C. Blower motor
D. 10-32 machine nuts (4)
E. Motor mounting plate
To rotate blower:
1. Remove the vent grille and grease filter.
2. Using a ³⁄₈" socket on a ratchet, reach into the plenum and
loosen the four #10-32 machine nuts one-half of a turn.
3. With the nuts loosened, the blower exhaust scroll can be
easily rotated downward.
4. Retighten each nut with the ³⁄₈" socket and ratchet.
5. Reinstall the grease filter and vent grille.

Rotate Blower - Optional

D
B
To rotate blower motor:
1. Using a ratchet with a ³⁄₈" socket and supporting the motor
with one hand, remove the four machine nuts that attach the
blower motor to the exhaust scroll.
2. Remove the blower motor and wheel assembly from the weld
studs.
C
A
B
A. Blower motor
B. Motor mounting plate
C. Weld stud location
3. When the motor mounting plate clears the threaded weld
studs, rotate the assembly clockwise 90° and reinstall the four
#10-32 machine nuts.
9