Table of Contents
Advertisement
Available languages
Available languages
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
Tools needed
8" or 10" Pipe wrench
I
8" or 10" adjustable
I
wrench
Flat-blade screwdriver
I
Phillips screwdriver
I
Adjustable wrench that
I
opens to 1" (2.5 cm) or 1"
(25 mm) hex-head socket
wrench
Security T-20 TORX
®†
I
driver
Parts supplied
Remove parts bag from dryer drum. Check that all parts were
included.
Foot boot (4)
I
Dryer foot (4)
I
† ® TORX is a registered trademark of Acument Intellectual Properties, LLC.
4
INSTALLATION REQUIREMENTS
Level
I
1
⁄
" socket and wrench
I
4
Vent clamps
I
Pipe-joint compound
I
resistant to LP gas
Caulk gun and caulk (for
I
installing new exhaust
vent)
Pliers
I
Stiff bladed putty knife
I
Service door lock cam
I
Location Requirements
If installing a gas dryer:
IMPORTANT: Observe all governing codes and ordinances.
I Check code requirements: Some codes limit or do not permit
installation of clothes dryers in garages, closets, or sleeping
quarters. Contact your local building inspector.
I Make sure that lower edges of the cabinet, plus the back and
bottom sides of the dryer, are free of obstructions to permit
adequate clearance of air openings for combustion air. See
"Recessed Area and Closet Installation Instructions" below
for minimum spacing requirements.
NOTE: The dryer must not be installed in an area where it will
be exposed to water and/or weather.
Advertisement
Table of Contents
