Using The Automatic Thread Cutting Function (End Color Trim); Using The Thread Trimming Function (Jump Stitch Trim); Bobbin Thread Is Too Tight - Brother 882-C40 Operational Manual

MAKING EMBROIDERY ADJUSTMENTS

■ Bobbin Thread is Too Tight

Upper thread on the right side of fabric seems to be
lifting/looping and bobbin thread is not seen on the
wrong side of fabric.
a Right side
b Wrong side
If this occurs, turn the slotted-head screw (-)
counterclockwise, being careful not to over-loosen
the screw, approximately 30-45 degrees to decrease
bobbin tension.
CAUTION
• When adjusting the bobbin case, be sure to
remove the bobbin from the bobbin case.
• DO NOT adjust the position of the phillips (+)
screw on the bobbin case as this may result in
damage to the bobbin case, rendering it
unusable.
• If the slotted-head screw (-) is difficult to turn,
do not use force. Turning the screw too much
or providing force in either (rotational)
direction may cause damage to the bobbin
case. Should damage occur, the bobbin case
may not maintain proper tension.
Using the Automatic Thread
Cutting Function
(END COLOR TRIM)
The automatic thread cutting function
the thread at the end of sewing each color. This
function is initially turned on. To turn this function
off, press key and then
be turned on or off during embroidering.
* This setting returns to its default
when the machine is turned off.
E-32
a
b
The thread trimming function
automatically trim any excess thread jumps within
the color. This function is initially turned on. To
turn this function off, press
will cut
embroidering.
. This function can
Press .
Press to turn off the automatic thread
cutting function.
→ The key will display as
* When one color thread is sewn, the machine will
stop without cutting the thread.
Using the Thread Trimming
Function (JUMP STITCH TRIM)
. This function can be turned on or off during
* Your customized setting remains after turning the
machine off and on.
a Jump stitch
will
key and then