Attaching The Dual Feed Foot; When The Snap-On Foot Of The Dual Feed Foot Is Detached; Using The Dual Feed Position Lever - Brother 882-C40 Operational Manual

USING FUNCTIONS BY CONNECTING THE ACCESSORY TO THE MACHINE

■ Attaching the Dual Feed Foot

a
Follow the steps from
the Embroidery Foot "W+" with LED
Pointer" on page B-61.
b
Position the dual feed foot to the presser
foot bar by aligning the notch of the dual
feed foot to the large screw.
Side view
c
Hold the dual feed foot in place with your
right hand, then using the included
screwdriver securely tighten the large
screw.
CAUTION
• Use the included screwdriver to firmly tighten
the screw. If the screw is loose, the needle may
strike the presser foot and possibly cause
injury.
d
Plug the connector of the dual feed foot
into the jack on the back of your machine.
B-68
a e
to of "Using
e
Press to unlock all keys and
buttons.
→ All keys and operation buttons are unlocked, and
the previous screen is displayed.
■ When the Snap-On Foot of the Dual
Feed Foot is Detached
If you push down on the front part of the dual feed
foot, the sole part of the dual feed foot will snap off.
Attach the sole by aligning the pins with the notches
and snap it into place.
a Pins
b Notches

■ Using the Dual Feed Position Lever

When the feed position lever is up, the black roller
belt on the dual feed is not engaged.