Setting The Bobbin - Brother 882-C40 Operational Manual

Embroidery and sewing machine
Table of Contents

Advertisement

a
If the thread becomes tangled under the
bobbin winder seat, press
stop the bobbin winding.
b
Cut the thread with scissors near the
pre-tension disk.
a Pre-tension disk
c
Push the bobbin winder switch to the right,
and then raise the bobbin at least 10 cm
(4 inches) from the shaft.
d
Cut the thread near the bobbin and hold the
thread end with your left hand. Unwind the
thread clockwise near the bobbin winder
seat with your right hand as shown below.
e
Wind the bobbin again.
Note
• Make sure that the thread passes through
the pre-tension disk correctly (page B-42).

Setting the Bobbin

once to
Press
example of the operation on the LCD (see page
B-39). Follow the steps explained below to
complete the operation.
• Use a bobbin thread that has been correctly
wound. Otherwise, the needle may break or
the thread tension will be incorrect.
• The included bobbin was designed specifically
for this sewing machine. If bobbins from other
models are used, the machine will not operate
correctly. Use only the included bobbin or
bobbins of the same type (part code: SA156,
(SFB: XA5539-151)).
*
a This model
b Other models
c 11.5 mm (approx. 7/16 inch)
• Before inserting or changing the bobbin, be
sure to press
injuries may occur if the "Start/Stop" button
or any other button is pressed and the machine
starts sewing.
a
Press
LOWER THREADING
in this order to display a video
CAUTION
Actual size
in the LCD, otherwise
.
Basic operations B-45
B
1

Advertisement

Table of Contents
loading

This manual is also suitable for:

882-c42

Table of Contents