Brother 882-C40 Operational Manual page 104

Embroidery and sewing machine
Table of Contents

Advertisement

USEFUL FUNCTIONS
Memo
• When the pivot setting is selected, the
height of the presser foot when sewing is
stopped can be changed according to the
type of fabric being sewn. Press
display "Pivoting Height" in the settings
screen. Press
the three heights (3.2 mm, 5.0 mm or 7.5
mm). To raise the presser foot further,
increase the setting. (Normally, 3.2 mm is
set.)
Note
• The "Needle Position - UP/DOWN" in the
settings screen, must be set in the down
position
for the pivot function to be
used. When "Needle Position - UP/DOWN"
is set in the raised position,
as light gray and cannot be used.
• The pivot function can only be used with
stitches where presser foot J or N is
indicated in the upper-left corner of the
screen. If any other stitch is selected,
appears as light gray and is not available.
• Use the "Presser Foot Lifter" button to
make sure the presser foot is lowered, and
then press the "Start/Stop" button to
continue sewing.
• If the pivot setting is selected,
beside "Presser Foot Height" in the settings
screen are not available and the setting
cannot be changed.
S-16
to
or
to select one of
appears
and
a
Select a stitch.
b
Press
to select the pivot setting.
→ The key appears as
c
Place the fabric under the presser foot with
the needle at the starting point of the
stitching, and then press the "Start/Stop"
button. The machine will begin sewing.
Memo
• If you press the "Start/Stop" button to
pause sewing, press it again to continue,
reverse stitches (or reinforcement stitches)
will not be sewn.
.

Advertisement

Table of Contents
loading

This manual is also suitable for:

882-c42

Table of Contents