Brother 882-C40 Operational Manual page 84

USING SENSOR FUNCTIONS WITH SEWING STITCH
Note
• The displayed distance is not the length of a
straight line connecting the current needle
position and the location touched with the
sensor pen. It is the length of a
perpendicular intersection for the location
touched with the sensor pen and the sewing
line.
a Displayed distance
• The following error message appears if the
area outside of the sensor pen touch range
is touched. Press
within the sensor pen touch range.
• When sewing with this setting, be sure to
gently hold the fabric and feed it straight.
• When using the sensor pen to specify the
sewing end point, be sure to hold the pen in
the same way as when it was calibrated,
otherwise the actual end point may be
different from the point that you specified.
• For best results, sew test stitching using the
same material and stitch pattern as those in
the actual project.
B-82
Decorative Stitch End Setting Key
h
, and then touch
i
The end of stitching is not adjusted.
When the end point is reached, sewing
stops immediately, even if the stitch
pattern is not complete.
The length of the stitch pattern is
adjusted so that sewing will stop at the
specified end point with a complete
pattern.
Note
• The decorative stitch end setting key is not
available with the following situations.
- When selecting the Utility Stitch patterns.
- When the decorative stitch end setting
key is grayed out.
- When specifying the sewing end point at
the point that needs adjustment more
than 10% of the length of a pattern, to
finish a pattern completely.
Press to apply the sewing end point
setting.
* The setting can also be applied by long touching an
adjustment area with the sensor pen.
→ When a sewing end point setting is specified,
appears in the upper-left corner of the screen.
Note
• If a different pattern is selected after the
sewing end point has been specified, the
end point setting is erased.
Start sewing again.
* The machine stops near the specified end point
automatically.