Brother 885-V95 Operation Manual page 161

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
d Lower the presser foot lever.
a Presser foot lever
e Press
a Start/stop button
CAUTION
● Use the embroidery frame that matches
the size of the pattern being embroidered.
Otherwise, the embroidery frame may be
hit by the presser foot and cause injury or
needle breakage.
f After progressing 5-6 stitches, press
(Start/stop button) to stop the machine.
g Use scissors to cut the thread at the beginning
of the stitching.
Cut the thread at the edge of the stitching.
Note
z If the thread is left at the beginning of the
stitching, it may be sewn over as you
continue embroidering the pattern, making it
very difficult to deal with the thread after the
pattern is finished. Trim the thread at the
beginning.
a
(Start/stop button).
a
h h Press (Start/stop button) again.
X
The embroidery begins again.
X
Stitching stops automatically with
reinforcement after one color has been
completed. When automatic thread cutting
is set, the thread is cut.
i Set up embroidery thread for the next color,
b
and repeat steps
X
When the last color is sewn, "Finished
sewing." will appear on the display. Press
, and the display will return to the
initial screen.
j Cut the excess thread.
Memo
z For the automatic cutting setting, refer to
"LCD (liquid crystal display) operation"
(page 153).
h
through .
Embroidering 159
4