Brother 885-V95 Operation Manual page 141

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
e Loosen the presser foot holder screw and
remove the presser foot holder.
Turn the screwdriver toward the back.
a Screwdriver
b Presser foot holder
c Presser bar
d Presser foot holder screw
f Hold the embroidery foot "Q" with your right
hand, as shown.
Hold the embroidery foot with your index
finger wrapped around the lever at the back of
the foot.
a Lever
g While pressing in the lever with your finger, fit
the embroidery foot bar over the needle clamp
screw to attach the embroidery foot to the
presser foot bar.
a
a Presser bar
b Needle clamp screw
c Embroidery foot bar
d
a
c
b
a
c
b
h Secure the embroidery foot with the presser
foot holder screw.
Set the embroidery foot perpendicular.
a
a Presser foot holder screw
i Tighten the presser foot holder screw.
Turn the screwdriver toward the front.
a
a Screwdriver
CAUTION
● Do not hit the needle with your finger or
the embroidery foot "Q" when attaching
it. The needle may break or cause injury.
● Be sure to tighten the screw with the
included screwdriver. If the screw is
loose, the needle may hit the presser foot
and break or bend.
● Before sewing, always turn the
handwheel toward you
(counterclockwise) slowly to make sure
that the needle does not hit the presser
foot. The needle may break or bend.
Attaching the Embroidery Foot 139
4