Saving Stitch Settings - Brother 885-V95 Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Saving stitch settings

This machine is preset with the default settings for the
stitch width (zigzag width), stitch length,
programmed thread-cutting, and automatic reverse/
reinforcement stitching for each stitch. However, if
you wish to save specific settings for a stitch so that
they can be used later, press
settings to save the new settings with the selected
stitch. This feature can be used only with utility
stitches. The settings you saved will not be cleared if
the machine is turned off.
■ To use a stitch length of 2.0 mm for the straight
stitch
a Select a straight stitch.
b Press
Memo
z The default stitch length is 2.5 mm.
c c Set the stitch length to 2.0 mm.
d Press
• To reset the selected stitch patterns to its
default settings, press
press
X
The confirmation message is displayed.
e Press
X
The next time that the same straight stitch is
selected, the stitch length is set to 2.0 mm.
after changing the
.
.
, and then
.
.
Note
z All stitch settings (stitch width (zigzag
width), stitch length, programmed thread-
cutting, and automatic reverse/
reinforcement stitching, etc.) are saved, not
just the setting that was changed. When the
same stitch pattern is selected, the last
settings saved are displayed even if the
machine was turned off. If the settings are
changed again and
is pressed to reset the setting to its
default, the new settings are not saved unless
is pressed another time.
Even if is pressed, the settings for
programmed thread-cutting and automatic
reverse/reinforcement stitching are saved in
the machine.
Useful Functions 67
2
is pressed, or if