Before Riding - Razor Pocket Mod Owner's Manual

ASSEMBLY AND SET-UP
q Inflating the Tires
Tires are inflated when shipped, but they invariably lose some pressure between the point of manufacturing and
your purchase.
1
Using a bicycle tire pump equipped
for a Schrader valve, inflate the tires
to the PSI indicated on the sidewall
of the tires.

BEFORE RIDING

q Charging the Battery
Your Pocket Mod may not have a fully charged battery; therefore it is a good idea to charge the battery prior to use.
• Initial charge time: 12 hours
• Recharge time: up to 12 hours,
depending on level of depletion.
• Fully charge battery before storing.
• When the scooter is not in regular use,
recharge the battery at least once a
month until normal use is resumed.
Charger
Note: Make sure power is turned
OFF when unit is not in use. If
the power switch is left on for an
extended period of time, the battery
may reach a stage at which it will
no longer hold a charge.
Need Help? Visit our website for updates and a list of authorized service centers at www.razor.com or call toll-free
at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time.
• Run time: Up to 30 minutes of continuous ride time.
Run time may vary depending on riding conditions,
climate and/or proper maintenance.
• Average battery life: 250 charge/discharge cycles
• To ensure long battery life, do not store the battery
in temperatures above 75° or below -10° F.
1
Plug the charger into a wall
outlet. If the lights on charger do
not light up, check the power to the
outlet. If necessary, try a different
outlet.
2
Turn power OFF before
charging. Plug the charger into the
charger port to charge unit.
4
Note: The pressurized air supplies
found at gasoline stations are
designed to inflate high-volume
automobile tires. If you decide to
use such an air supply to inflate
your Pocket Mod tires, first make
sure the pressure gauge is working,
then use very short bursts to
inflate to the correct PSI. If you
inadvertently over-inflate the
tires, release the excess pressure
immediately.
WARNING:
Rechargeable batteries are only to
be charged under adult supervision.
Always disconnect your Pocket Mod
from the charger before cleaning
with liquid.
Note: If your charger does not
look like the one illustrated,
your unit has been supplied
with an alternative charger.
The specifications and charging
procedure would not change.
The charger has a small window
with one LED to indicate the charge
status. Refer to the illustration
on the charger unit for the actual
"charging" and "charged" status
indications for your model charger.
Chargers have built-in over-charge
protection to prevent battery from
being over-charged.
Charger will get warm during use.
This is normal for some chargers
and is no cause for concern. If your
charger does not get warm during
use, it does not mean that it is not
working properly.
WARNING: Failure to
recharge the battery at least once a
month may result in a battery that
will no longer hold a charge.