Before You Begin - Razor Pocket Mod Owner's Manual

BEFORE YOU BEGIN

Remove contents from box. Remove the plastic separators that protect the components from damage during shipping.
Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during
shipping. Because the Pocket Mod is 95 percent assembled and packed at the factory, there should not be any
problems, even if the box has a few scars or dents.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult.
Allow up to 15 minutes for assembly.
Allow up to 12 hours for initial charge (see page 4 for charging information).
Throttle
Charger Port
Required Tools
3mm, 5mm and 6mm
Allen wrenches
(Included)
Need Help? Visit our website for updates and a list of authorized service centers at www.razor.com or call toll-free
at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time.
Brake Lever
On/O
Switch
Storage Compartment
Under Seat
14mm (Daisy only)
and 15mm open wrenches
(Included)
8mm and 10mm open wrenches
(Not Included)
Charger
(Note: Charger design may vary
from one shown)
Kick Stand
Chain Guard
Spoke tightener Bicycle tire pump for
(Included) Schrader valves, with
pressure gauge
(Not Included)
2
WARNING:
DO NOT USE NON-RAZOR
PRODUCTS WITH YOUR
RAZOR POCKET MOD.
The Pocket Mod has been built to
certain Razor design specifications.
The original equipment supplied at
the time of sale was selected on
the basis of its compatibility with
the frame, fork and all other parts.
Certain aftermarket products may
or may not be compatible and may
void your warranty.
Phillips screwdriver
(Not Included)