3Com 3C17500 Installation Manual page 37

Flash file system init....done
Board self testing...........................
The board is steady
SlotNo of this board is 4
The MCX is existent
BootRom main system CRC check is OK
82559 register testing is OK
EPLD1 testing is OK
EPLD2 testing is OK
16c2552 register testing is OK
Please check LEDs......................LED testing finished
The switch's Mac address is 0040.9c30.b2d4
Press Ctrl+B to enter Boot Menu...
To access the BOOT Menu, press Ctrl+B during the five seconds that "Press Ctrl-B
to enter Boot Menu..." displays. After five seconds, the system begins program
decompression. If you want to access the BOOT Menu after this, you must reboot
the switch.
1 Press Ctrl+B. The system displays:
Initialize flash file system. Please wait!
Password :
CAUTION: While using the switch, keep in mind the modified BOOTROM
password.
2 Enter the BootROM password. After entering the correct password (no password
is set for the switch by default), the system displays the Main Menu:
MAIN MENU
1. Boot with default mode
2. Boot from Flash
3. Boot from CF card
4. Enter serial submenu
5. Enter ethernet submenu
6. Modify Flash description area
7. Modify bootrom password
0. Reboot
Enter your choice(0-7):
Upgrading Software 37