Table of Contents
Advertisement
9 - 14 DS9208-1D Product Reference Guide
User-Programmable Supplementals
Supplemental 1: Parameter # F1h 43h
Supplemental 2: Parameter # F1h 44h
If you selected a Supplemental User-Programmable option from
page
9-11, select User-Programmable Supplemental 1 to set the 3-digit prefix. Then select the 3 digits using
the numeric bar codes beginning on
3-digit prefix. Then select the 3 digits using the numeric bar codes beginning on
User-Programmable Supplemental 1
UPC/EAN/JAN Supplemental Redundancy
Parameter # 50h
If you selected Autodiscriminate UPC/EAN/JAN Supplementals, this option adjusts the number of times to
decode a symbol without supplementals before transmission. The range is from two to thirty times. Five or
above is recommended when decoding a mix of UPC/EAN/JAN symbols with and without supplementals. The
default is 10.
Scan the bar code below to set a decode redundancy value. Next, scan two numeric bar codes in
Numeric Bar
Codes. Enter a leading zero for single digit numbers. To correct an error or change a selection,
scan
Cancel on page
UPC/EAN/JAN Supplemental Redundancy
page D-1.
D-2.
Decode UPC/EAN/JAN Supplementals on
Select User-Programmable Supplemental 2 to set a second
User-Programmable Supplemental 2
page D-1.
Appendix D,
Advertisement
Table of Contents
