Host Parameters - Motorola DS9208-1D Product Reference Manual

6 - 4 DS9208-1D Product Reference Guide
RS-232 Host Parameters
Various RS-232 hosts use their own parameter default settings. Selecting standard, ICL, Fujitsu,
Wincor-Nixdorf Mode A, Wincor-Nixdorf Mode B, OPOS/JPOS, Olivetti, Omron, or Common Use Terminal
Equipment (CUTE-LP/LG bar code readers) sets the defaults listed in
Terminal Specific RS-232
Table 6-2
Parameter
Baud Rate 9600
Parity Even
Stop Bit Select One
ASCII Format 8-Bit
Hardware RTS/CTS
Handshaking Option 3
Software None
Handshaking
Serial Response 9.9 Sec.
Timeout
RTS Line State High
Beep On <BEL> Disable
Transmit Code ID Yes
Data Transmission Data/Suffix
Format
Prefix None
Suffix CR (1013)
In the Nixdorf Mode B, if CTS is low, scanning is disabled. When CTS is high, scanning is enabled.
If you scan Nixdorf Mode B without connecting the digital scanner to the proper host, it may appear unable
to scan. If this happens, scan a different RS-232 host type within 5 seconds of cycling power to the digital
scanner.
The CUTE host disables all parameter scanning, including Set Defaults. If you inadvertently select CUTE,
scan *Enable Parameter Bar Code Scanning (01h) on page 4-5, then change the host selection.
Wincor-
ICL Fujitsu Nixdorf
Mode A
9600 9600
None Odd
One One
8-Bit 8-Bit
None RTS/CTS
Option 3
None None
2 Sec. None
Low Low
Disable Disable
Yes Yes
Data/Suffix Data/Suffix
None None
CR (1013) CR (1013)
Table 6-2.
Wincor-
Nixdorf Mode Olivetti
B/OPOS/JPOS
9600 9600
Odd Even
One One
8-Bit 7-Bit
RTS/CTS None
Option 3
None ACK/NAK
None 9.9 Sec.
Low = No data to Low
send
Disable Disable
Yes Yes
Data/Suffix Prefix/Data/
Suffix
None STX (1002)
CR (1013) ETX (1003)
Omron CUTE
9600 9600
None Even
One One
8-Bit 7-Bit
None None
None None
9.9 Sec. 9.9 Sec.
High High
Disable Disable
Yes Yes
Data/Suffix Prefix/Data/
Suffix
None STX (1002)
CR (1013) CR (1013)
ETX (1003)