Table of Contents
Advertisement
CHAPTER 4 USER PREFERENCES &
Introduction
You can program the digital scanner to perform various functions, or activate different features. This chapter
describes each user preference feature and provides programming bar codes for selecting these features.
The digital scanner ships with the settings shown in
Default Parameters
programming is not necessary.
To set feature values, scan a single bar code or a short bar code sequence. The settings are stored in
non-volatile memory and are preserved even when the digital scanner is powered down.
NOTE Most computer monitors allow scanning the bar codes directly on the screen (when using the imaging
engine). When scanning from the screen, be sure to set the document magnification to a level where you
can see the bar code clearly, and bars and/or spaces are not merging.
If not using a USB cable, select a host type (see each host chapter for specific host information) after the
power-up beeps sound. This is only necessary upon the first power-up when connected to a new host.
To return all features to default values, scan the
programming bar code menus, asterisks indicate (
MISCELLANEOUS OPTIONS
for all host device and miscellaneous defaults). If the default values suit requirements,
*
Indicates Default
Table 4-1 on page 4-2
Set Default Parameter on page
*
) default values.
*
High Volume
Feature/Option
(00h)
Option Hex Value
(also see
Appendix A, Standard
4-4. Throughout the
Advertisement
Table of Contents
