Operation; Start-Up And Normal Operation; Operation On Battery Power - Eaton 700 Installation And User Manual

3.1 Start-up and normal operation

For the initial start, AC power must be present to detect any wiring errors. Subsequently, the UPS can start even if
AC power is not present.
ESC
UPS personalisation
If UPS personalisation is desired, it is advised to enter the personalisation mode at this time.
This mode may be entered using the buttons on the control panel or the Personal Solution-Pac software (Windows)
included on the Solution-Pac CD-ROM provided by EATON.

3.2 Operation on battery power

Transfer to battery power
ESC
Low-battery warning
ESC
Press button (27) for approximately 1 second.
20
The buzzer beeps once and all the LEDs go ON simultaneously.
21
The buzzer then beeps twice during the self-test, then button (27)
22
remains ON, indicating that the load outputs are supplied.
The connected devices are protected by the UPS.
LED (20) is ON.
If LED (22) is ON, a fault has occurred (see the
section).
25
During normal operation, the scroll button (25) may be used to read
UPS measurements (AC input voltage, operating mode, battery
27
capacity and UPS serial number).
The connected devices continue to be supplied by the UPS when AC
20
power is no longer available. The necessary energy is provided by
21
the battery.
LEDs (20) and (21) go ON.
The audio alarm beeps every ten seconds.
The connected devices are supplied by the battery.
The display indicates the remaining backup time.
LEDs (20) and (21) go ON.
20
The audio alarm beeps every three seconds.
21
The remaining battery power is low.
Shut down all applications on the connected equipment because
automatic UPS shutdown is imminent.

3. Operation

" "
Troubleshooting
- Page 15
34008097EN/AE