Advertisement
Technical description and operating instructions
Connection
Front, Center and Rear loudspeakers
The Motiv 10 set in the 5.1 configuration with an
active subwoofer can be connected to any com-
mon Dolby Digital /DTS-/5.1-/6.1-/7.1-AV receiver/
amplifier. Do not occupy the rear renter input jack
of the 6.1/7.1 receiver.
Subwoofer
Connect the subwoofer output (Sub Out) of your
Dolby Digital /DTS AV receiver / amplifier via a
mono RCA cable using the right line input of the
subwoofer. The left input (line input L) remains
unoccupied. Only if the Y-adapter is used (see Ac-
cessories page 6), you can use both inputs of the
subwoofer.
MO 10 FCR
left
Front left
Rear left
MO 10 D
left
AV receiver
AV receiver
Subwoofer Output
R
MO 10 SW
Input
Pre Out
Subwoofer
Output
AV receiver
Front LS
Center LS
Rear LS
Pre Out
Input R
RCA output
RCA input
MO 10 FCR
MO 10 FCR
Center
right
Center
Front right
Rear right
MO 10 D
right
Load capacity
Please note that the information
on the load capacity of the
satellite loudspeakers refers only
to use with AV receiver which
protects the satellites using
internal filtering from a more
intensive load by woofer signals.
Plus and Minus
Please make sure that the loud-
speaker is wired with correct po-
larity - as shown on the picture.
Almost all loudspeaker cables
are marked to make it easier for
you. Mostly the insulation of one
MO 10 SW
of the cables is serrated while
the other one is smooth. Some
manufacturers also colour-code
both cables. Note that the mark-
ing in your installation always
has the same meaning, i.e. the
cable with the serrated coating
must be consistently connected
to the plus pole.
Connection of the loudspeak-
ers to the AV surround
receiver using the example of
the 5.1 Cinema Set.
· Motiv 10
9
Advertisement
