Advertisement
Mounting • Settings
* Load capacity
Please note that the information
on the load capacity of the
satellite loudspeakers refers only
to the use with AV receiver which
protects the satellites with the
help of internal filtering against
a more intense load by low
frequency signals.
10
· Motiv 10
Technical description and operating instructions
Mounting of the Satellites
MO 10 FCR
The satellites MO 10 FCR can be located in three
ways: shelf, wall, stand.
For installation on the shelf please fasten four
enclosed rubber pads on the corners of the satel-
lite enclosure.
Besides you should bond two small rubber pads to
the rear side of the enclosure, e.g. on the left and
right of the rear.
Fixation on the optional stand M 10 P (see page 7)
is carried out using the screws enclosed to the
stand - see mounting instructions of the stand.
MO 10 D
In order for the dipoles to unfold their full poten-
tial, fasten them on the wall. Preferably at a height
three screws and fastened to the enclosure using
one screw.
Please note that in this case the box must be
mounted UPSIDE DOWN. This means: the connect-
ing panel faces UPWARDS!
Set-up of the AV receiver / amplifier
Select the parameters "small" or "normal" (not
"large") for the satellites of your system Motiv
10 set in the bass/loudspeaker management pro-
gram ("Speaker Setup") of the AV receiver. This
ensures that the satellites can be fully loaded
and that the subwoofer and Front loudspeakers
harmonise perfectly with each other. *
The subwoofer must be set to "On" in the bass/
For wall mount-
loudspeaker management ("Speaker Setup") of
ing please use the
the receiver. The suitable cross-over frequency
reverse
holding
that has to be set is 120 Hz for Motiv 10.
clamp that can be
Settings for the subwoofer
fixed on a screw
fastened on the
Set the subwoofer to "Full-Range" operation (see
wall.
➎ page 11). This means that the phase and the
cross-over frequency are determined by the AV
receiver - its settings are commanding.
Modern AV receivers set the subwoofer phase
correctly during automatic adjustment of the
subwoofer in the "Speaker Setup" program. In
this respect, the phase of the subwoofer should
be left in position "0°".
The volume setting of the subwoofer will devi-
ate slightly when playing music compared to the
home theatre depending on the quality of the
record and mixing. While massive woofer part
prevails with highly efficient DVDs, the desired
level cannot be heard when playing music (espe-
of 1.40–2.10 m
cially if the set has been preset for optimal DVD
(see also page 10
rendering). In this situation your personal taste
of these operat-
is deciding for the best compromise correlation
ing instructions).
between both sources.
To do so please
use the enclosed
In this way you can find the best volume of the
wall bracket which
subwoofer:
can be mounted
We recommend to avoid choosing the automatic
on the wall using
setting by means of an integrated measuring de-
vice (if the receiver has such an option) but rath-
er to set the subwoofer in the bass management/
loudspeaker management ("speaker setup") at
higher value between +4 and +12 dB, in order to
ensure functioning of the Standby mode and then
to determine the optimal level of the subwoofer
through listening tests.
Advertisement
