Kenwood DNX6140 Instruction Manual page 108

Connection
Ignition key
switch
1-
If you connect the ignition wire (red) and the battery
~
wire (yellow) to the car chassis (ground), you may
cause a short circuit, that in turn may start a fire. Always
connect those wires to the power source running
through the fuse box.
ACC
A
B
Ignition wire (Red)
A~=====~
Car fuse box
Car fuse box
(Main fuse)
Battery wire (Yellow)
B~=====~
Ground wire (Black)
8
C
~
(To car chassis)
Antenna Cord
( I
==+1
[)=
Steering remote control input
(Light Blue/Yellow)
Reveres sensor wire (PurplelWhite)
To steering remote
To use the steering wheel remote control feature, you need to an
exclusive remote adapter (not supplied) matches your car is required.
~
~
For the sake of safety, be sure to connect the parking sensor.
'---~
Connect to vehicle's reverse lamp harness when
using the optional rear view camera.
~
Connect
to
the vehicle's parking brake
~ detection switch harness.
Parking sensor wire (Light Green)
Dimmer control wire (OrangelWhite)
To car light control switch :
-.e-:p====================
,
'
Connect to the terminal that is grounded when either: : Mute wire (Brown)
the telephone rings or during conversation.:
~==================
Depending on what antenna you are using,: : Motor antenna control wire (Blue)
connect either to the control terminal of the motor antenna, or to the power:
terminal for the booster amplifier of the film or short pole-type antenna. :
~==================
: Power control wire (BluelWhite)
When using the optional power amplifier,
connect to its power control terminal. : _;
~
If no connections are made, do not let the cable come out from the tab.
4
I
DNX6140lDNX6000EXIDNXS 140lDDXS 14/DDXS034/DDXS034BT