Unified Switch Installation; Quick Starting The Networking Device; System Information And System Setup - D-Link DWS-3000 Series Configuration Manual

Unified Switch Installation

This section contains procedures to help you become acquainted quickly with the switch
software.
Before installing the Unified Switch, you should verify that the switch operates with the most
recent firmware.

Quick Starting the Networking Device

1. Configure the switch for In-band or Out-of-Band connectivity. In-band connectivity
allows access to the Unified Switch locally or from a remote workstation. You must con-
figure the device with IP information (IP address, subnet mask, and default gateway).
2. Turn the Power ON.
3. Allow the device to load the software until the login prompt appears. The device initial
state is called the default mode.
4. When the prompt asks for operator login, do the following steps:
-
Type
admin
require administrator account rights, D-Link suggests logging into an administrator
account.
Do not enter a password because the default mode does not use a password - after typ-
ing
admin,
-
The CLI User EXEC prompt is displayed.
-
Type
enable
-
Type
configure
-
Type
exit
-
Enter
?
For more information about the configuration modes, see the CLI Command
NOTE:
Reference.

System Information and System Setup

This section describes the commands you use to view system information and to setup the
network device. The tables below contain the Quick Start commands that allow you to view or
configure the following information:
•
Software versions
•
Physical port data
•
User account management
•
IP address configuration
•
Uploading from Networking Device to Out-of-Band PC (Only XMODEM)
•
Downloading from Out-of-Band PC to Networking Device (Only XMODEM)
•
Downloading from TFTP Server
•
Restoring factory defaults
For each of these tasks, a table shows the command syntax, the mode you must be in to
execute the command, and the purpose and output of the command. If you configure any
network parameters, you should execute the
at the login prompt. Since a number of the Quick Setup commands
press Enter two times.
to switch to the Privileged EXEC mode from User EXEC.
to switch to the Global Config mode from Privileged EXEC.
to return to the previous mode.
to show a list of commands that are available in the current mode.
command.
write
Unified Switch Installation
1 Getting Started
21