Signal Information; Update Menu - Yamaha neoHD WiFi YMC-700 Owner's Manual

Setup menu
• Network Standby (YMC-700 only)
Use this feature to select whether or not this unit will
accept commands via LAN network when it is in the
standby mode.
Signal information
':~;;};
%0.."
"'"~.
)" ' V
Use this to display audio and video signal information.
The displayed information is as follows:
Video information
Off Does not accept operations via LAN network
when in the standby mode.
On
Accepts operations via LAN network when in
the standby mode.
When in the standby mode. the power indicator
is lit dimly.
Signal Type
Resolution
Type of source video signal and video signal
output from the HOMI OUT jack.
Resolution of the input signal (analog or
HOM!) and the output signal (HDMI).
Note":!
Audio information
When "Network Standby" is set to "On", the amount of power
consumed in the standby mode increases.
• Screen Saver
Screen saver
Select a type of screen saver.
Off
Screen saver is not activated.
Decode Status
Decode Channel
Air Surround
Xtreme
No
Signal formal.
Number of source channels in the input
signal.
State of the Air Surround Xtreme function.
Waiting time
Use this menu to set the amount of time before the screen
saver is activated.
Control range: Imin to IOmin
Initial setting: 5min
Control step: Imin
Press ENTER to set the value.
Preview
When you select this menu, preview is displayed. Press
BACK to return to the previous screen.
Use this menu to update the firmware of this unit. For
details on how to update the firmware, refer to the
information supplied with updates.
Updates the firmware of this unit using the
USB memory.
USB Update
• "- - -" appears when this unit cannot display the corresponding
information.
• Even if you make settings to output bitstreams directly, some
players convert Dolby TrueHO or Dolby Digital Plus bitstreams
to Dolby Digital bitstreams.
The selected photos
(A'
P. 27) are used for
the screen saver.
The Yamaha logo and neoHO logo are used
for the screen saver.
Photos
Logos
• Factory Reset
Use this menu to reset the system to the factory defaults.
Network Update
(YMC-700 only)
Updates the firmware of this unit via the
network.
System
Information
Displays the software version and system ID
of this unit.
• This procedure completely resets all the parameters of this unit.
• When you execute the "factory reset" command, this unit turns
off then back on automatically.
To start updating the firmware. select "USB Update" or "Network
Update".
Yes
No
Resets the system to the factory defaults.
Cancels reselling.
• Do not use this feature unless you need to update the firmware.
• Be sure to read the information supplied with updates before
performing firmware updates.
• DO NOT unplug the power cord during updating.
44
En