Option Menu - Yamaha neoHD WiFi YMC-700 Owner's Manual

Setup menu
The playback screen of the selected input
source is displayed when this unit is turned
on.
You cannot select
FM
Radio. Rhapsody. Net
Radio. PC Content. Bluetooth. or USB.
The playback screen of the audio source you
listened to the last time is displayed when
this unit is turned on.
The top menu is displayed when this unil is
turned on.
Left
Right
Down
v
<
>
Top Menu
Last
Activities
~'(,)~
Press
ENTER when the adjustment is finished.
• HOMI Standby Through
Use this feature to decide whether or not to allow the
HDMI signals input to the HDMIIN jacks to pass through
this unit when this unit is in the standby mode.
• GUI position
Use this feature to adjust the vertical and horizontal
position of the menu screen.
Control range: -5 (downwardlleft) to +5 (upward/right)
You cannot use this feature with
CONTROL on the top panel.
• Initial Screen - CONTROL Button
You can set the initial screen displayed when this unit is
turned on using CONTROL on the remote control.
The top menu is displayed when this unit is
turned "n.
Top Menu
Aim the remote control of the TV at the remote control
sensor of this unit within the range of 10 cm to 2.5 m (4 in.
to
8
ft.).
You can adjust the optional system settings.
The choices indicated in bold are selected by default.
• Initial Screen - POWER Button
You can set the initial screen displayed when this unit is
turned on using POWER.
If the other remote control uses infrared rays, this unit can learn
most of its function. However, you may not be able to program
some special signals or extremely long transmissions.
3
Select "Finished" and then "Yes" to exit the
learning process.
2
Select "Learn" and immediately press the TV
power control button on the remote control
of the TV.
When learning was successful, "Code learning was
successful" appears.
If learning was unsuccessful, "Code learning failed"
appears. In this case, place the remote control near
the remote control sensor of this unit and select
"Retry", or select "Cancel" to cancel the learning
process.
Last
Activities
The playback screen of the audio source you
listened to the last time is displayed when
this unit is turned on.
The playback screen of the selected input
source is displayed when this unit is turned
on.
You cannot select
FM
Radio. Rhapsody, Net
Radio. PC Content. Bluetooth, or USB.
Off
HOMII - 3
Oisables the HOMI standby through feature.
HOMI signals do not pass through this unit
when this unit is in the standby mode.
HOMI signals pass through this unit (from the
corresponding HDMI IN jack) even when this
unit is in the standby mode.
When in the standby mode. the power indicator
is lit dimly.
When "HOMI Standby Through" is set to options other than
"Off'. the amount of power consumed in the standby mode
increases.
43
En