Configuration Mode - ICM Controls SC 5811 Manual

The configuration mode is used to set the SC5811 to match your heating/cooling system . The SC5811
functions with heat pump, air conditioning, gas, oil or electric heat systems .
To configure the SC5811, perform the following steps:
1 . Verify the SC5811 is in the OFF mode .
Press the SYS (left) button until off mode displays .
2 . Remove the cover of the thermostat by gently pulling near one of the
corners at the top of the thermostat .
3 . Press the CONFIG button for 1 second while the SC5811 is in OFF mode .
Press the up or down button to change settings within each screen .
Press the right button to advance to the next screen .
Note: Pressing the left button will return you to the previous screen .
To exit configuration mode, press the CONFIG switch for 1 second .

Configuration Mode

PM
OFF
CONFIG
S1 S2 R C W Y1 W2 Y2 G W3
FP O/B
RESET CONFIG
Up
button
Down
button
Left Right
button button