Configuration Mode - ICM Controls SC 2811 Installation, Operation & Application Manual

The configuration mode is used to set the SC2811 to match your heating/cooling system. The SC2811 functions with heat
pump, air conditioning, gas, oil or electric heat systems.
To configure the SC2811, perform the following steps:
1. Remove the cover of the thermostat by gently pulling on one of the corners.
2. Simultaneously hold the SW5 and SW6 buttons in for 5 seconds while the SC2811 is in OFF mode.
3. Press the or button to change settings within each screen.
4. Press the SW6 button to advance to the next screen.
Note: The SW5 button will return you to the previous screen.
5. To exit configuration mode, slide the Mode switch to Heat or Cool.
Configuration Mode Settings
The setup screens for Configuration Mode are as follows:
1. Heat Pump and Non Heat Pump – Press the
pump, or non-heat pump system. For heat pumps, there will be an anti-short
cycle delay for heating and cooling.
• 1 = Heat pump system
• 0 = Non-heat pump system
Press the SW6 button to advance to the next screen.
2. Heat Source (Gas or Electric) – (Appears for non heat pump systems only)
Change between "g" (Gas) and "E" (Electric).
Press the or button to set heat source.
Press the SW6 button to advance to the next screen.


Configuration Mode

or button to configure as heat
REMOTE
SET
ROOM
DIFF
FILTER
REMOTE
SET
ROOM
DIFF
FILTER