Table of Contents
Advertisement
English
Connect the SDI outputs from your
cameras into the BNC inputs on the
rear of the DVR.
Connect the RS485 multi
connection board to the
RS485 input on the DVR.
Connect the
and BLACK cable to -.
RS485 connection:
The RS485 connection requires a plug to be attached to the wire terminals
RED
to + and BLACK to - as marked on the plastic sheath
provided using
of the connector nears the screws. Use a precision flat-head screwdriver
and ensure the wires are held firmly and won't slip out over time. Don't
use too much force when tightening the screws. Also, the PTZ address
needs to be changed for the RS485 control to work - see page 26.
If you've got a TV or monitor with
HDMI in, connect to the HDMI port on
the DVR.
Connection Diagram
RED
cable to +
Connect the power
adapter(s) to a wall
outlet.
If you've got a monitor with VGA
but not HDMI, connect it to the VGA
output on the DVR.
Connect the DC 12V
output from the power
supply to the power
input.
Connect
your
cameras
to
power, using a
power
splitter
(if included).
Connect an ethernet
cable from the LAN port
on the DVR to a spare
port on your router.
7
Advertisement
Table of Contents
