Dell S300wi User Manual page 55

NOTE:
1. When you want to create 3D experience, you will need a few other components
including:
a PC/NB with a 120 Hz signal output quad buffered graphics card.
b "Active" 3D glasses with DLP Link™.
c 3D content. See "Note 4".
d 3D Player. (Example: Stereoscopic Player...)
2. Enable the 3D function when it satisfies any of the below-mentioned conditions:
a PC/NB with graphics card, capable of outputting at 120Hz signal via VGA or
HDMI cable.
b inputs a suite of 3D content via Video and S-Video.
3. When projector detects either of the inputs (mentioned above), the enable 3D
display on "SETUP" -> "3D Display" OSD works.
4. Current 3D support time is as indicated:
a VGA/HDMI 1280 x 720 120 Hz
b Composite/S-Video 60 Hz
c Component 480i
5. The recommended VGA signal for NB is Single mode output (Dual mode is not
recommended)
3D Sync Invert—
wearing DLP 3D goggles, you may need to execute 'Invert' to get
best match of left/right image sequence to get the correct image.
(For DLP 3D goggles)
S VGA O
TANDBY UTPUT
standby status. Default is Off.
W / N
IRELESS ETWORK
configure the Wireless / Network settings.
If you see a discrete or overlapping image while
—Select On or Off the VGA output function at projector
—Select On to activate wireless / network function. Press
Using Your Projector
to
55