Table of Contents
Advertisement
4. Hold the Left Upright (89) against the Base
(94). Be careful not to pinch the Upright
Wire (81). Insert two 3/8" x 1 1/4" Bolts (8) with
two 3/8" Star Washers (13) and two 3/8" x 2
3/4" Bolts (7) into the Left Upright.
Partially tighten the 3/8" x 2 3/4" Bolts (7) and
the 3/8" x 1 1/4" Bolts (8) until the heads of the
Bolts touch the Left Upright (89); do not fully
tighten the Bolts yet.
Attach the Right Upright (not shown) in the
same way. Note: There are no wires on the
right side.
5. Identify the Left Base Cover (82) and the Right
Base Cover (83). Slide the Left Base Cover onto
the Left Upright (89). Slide the Right Base Cover
onto the Right Upright (90). Do not press the
Base Covers into place yet.
Identify the Left Upright Cover (79) and the
Right Upright Cover (80). Slide the Left Upright
Cover onto the Left Upright (89). Slide the Right
Upright Cover onto the Right Upright (90).
4
89
7
13
8
13
94
5
89
79
82
8
81
80
90
83
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Performance 600 and is the answer not in the manual?
Questions and answers
Belt on proform performance 600c has slid too far to the left and the lefdt side of the belt is turned over by a q1/2 inch. belt is tight and I tried to turn hex screw and that isn't helping.
To fix a misaligned belt on a ProForm Performance 600 treadmill:
1. Remove the key and unplug the power cord.
2. If the belt has shifted to the left, use a hex key to turn the left idler roller bolt clockwise 1/2 turn.
3. If the belt has shifted to the right, turn the left idler roller bolt counterclockwise 1/2 turn.
4. Be careful not to overtighten the belt.
5. Plug in the power cord, insert the key, and run the treadmill for a few minutes.
6. Repeat the adjustment if necessary until the belt is centered.
This answer is automatically generated