Table of Contents
Advertisement
8. Set the console assembly face down on a soft
surface to avoid scratching the console assem-
bly. Remove the two Screws (A). Next, lift off the
Crossbar (93). Discard the two Screws.
9. IMPORTANT: To avoid damaging the
Crossbar (93), do not use power tools and
do not overtighten the #10 x 3/4" Screws (9)
or the #10 x 3/4" Flat Head Screws (112).
Orient the Crossbar (93) as shown. Attach the
Crossbar to the Handrails (87, 88) with two #10
x 3/4" Flat Head Screws (112), two #10 x 3/4"
Screws (9), and two 1/4" Star Washers (35) as
shown. Start all four Screws, and then tighten
each of them.
10. With the help of a second person, hold the con-
sole assembly near the Left Handrail (88).
Connect the Upright Wire (81) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER. Remove the wire tie from the
Upright Wire.
8
93
9
112
9
35
10
Console
Wire
81
10
Console
Assembly
A
112
9
35
93
88
Console
Assembly
Console
Wire
81
Wire
Tie
87
88
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Performance 600 and is the answer not in the manual?
Questions and answers
Belt on proform performance 600c has slid too far to the left and the lefdt side of the belt is turned over by a q1/2 inch. belt is tight and I tried to turn hex screw and that isn't helping.
To fix a misaligned belt on a ProForm Performance 600 treadmill:
1. Remove the key and unplug the power cord.
2. If the belt has shifted to the left, use a hex key to turn the left idler roller bolt clockwise 1/2 turn.
3. If the belt has shifted to the right, turn the left idler roller bolt counterclockwise 1/2 turn.
4. Be careful not to overtighten the belt.
5. Plug in the power cord, insert the key, and run the treadmill for a few minutes.
6. Repeat the adjustment if necessary until the belt is centered.
This answer is automatically generated