Table of Contents
Advertisement
18. Attach the Rear Feet (57) to the Frame (56) as
shown with four #8 x 3/4" Screws (2).
See step 16. Discard the piece of cardboard.
Lower the Frame (56) (see HOW TO LOWER
THE TREADMILL FOR USE on page 25).
19. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill.
Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex keys is
used to adjust the walking belt (see pages 27 and 28).
18
57
2
56
14
57
2
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Performance 600 and is the answer not in the manual?
Questions and answers
Belt on proform performance 600c has slid too far to the left and the lefdt side of the belt is turned over by a q1/2 inch. belt is tight and I tried to turn hex screw and that isn't helping.
To fix a misaligned belt on a ProForm Performance 600 treadmill:
1. Remove the key and unplug the power cord.
2. If the belt has shifted to the left, use a hex key to turn the left idler roller bolt clockwise 1/2 turn.
3. If the belt has shifted to the right, turn the left idler roller bolt counterclockwise 1/2 turn.
4. Be careful not to overtighten the belt.
5. Plug in the power cord, insert the key, and run the treadmill for a few minutes.
6. Repeat the adjustment if necessary until the belt is centered.
This answer is automatically generated