Table of Contents
Advertisement
20. Never leave the treadmill unattended while it
is running. Always remove the key, unplug
the power cord, and press the power switch
into the off position when the treadmill is not
in use. (See the drawing on page 5 for the lo-
cation of the power switch.)
21. Do not attempt to raise, lower, or move the
treadmill until it is properly assembled. (See
ASSEMBLY on page 6, and HOW TO FOLD
AND MOVE THE TREADMILL on page 25.)
You must be able to safely lift 45 lbs. (20 kg)
to raise, lower, or move the treadmill.
22. When folding or moving the treadmill, make
sure that the storage latch is holding the
frame securely in the storage position.
23. Never insert any object into any opening on
the treadmill.
SAVE THESE INSTRUCTIONS
24. Inspect and properly tighten all parts of the
treadmill regularly.
DANGER:
25.
cord immediately after use, before cleaning the
treadmill, and before performing the mainte-
nance and adjustment procedures described in
this manual. Never remove the motor hood un-
less instructed to do so by an authorized ser-
vice representative. Servicing other than the
procedures in this manual should be performed
by an authorized service representative only.
26. This treadmill is intended for in-home use
only. Do not use this treadmill in a commer-
cial, rental, or institutional setting.
27. Over exercising may result in serious injury
or death. If you feel faint or if you experience
pain while exercising, stop immediately and
cool down.
4
Always unplug the power
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Performance 600 and is the answer not in the manual?
Questions and answers
Belt on proform performance 600c has slid too far to the left and the lefdt side of the belt is turned over by a q1/2 inch. belt is tight and I tried to turn hex screw and that isn't helping.
To fix a misaligned belt on a ProForm Performance 600 treadmill:
1. Remove the key and unplug the power cord.
2. If the belt has shifted to the left, use a hex key to turn the left idler roller bolt clockwise 1/2 turn.
3. If the belt has shifted to the right, turn the left idler roller bolt counterclockwise 1/2 turn.
4. Be careful not to overtighten the belt.
5. Plug in the power cord, insert the key, and run the treadmill for a few minutes.
6. Repeat the adjustment if necessary until the belt is centered.
This answer is automatically generated