Troubleshooting/Error Messages - JVC KW-NT3HDT Instructions Manual

Troubleshooting/error messages

What appears to be trouble is not always serious. Check the following points before calling a service center.
• For operations with the external components, refer also to the instructions supplied with the adapters used for the
connections (as well as the instructions supplied with the external components).
Symptoms
No sound comes out of the speakers.
The screen is not clear and legible.
The unit does not work at all.
The touch panel does not respond properly.
Navigation guidance or AV source is hard to
listen to.
<Adaptive Volume> setting has no effect
even though it is activated.
CD Text or Tag information of track or song,
etc. is not displayed correctly.
"System start up failed."
Guidance does not start.
You cannot operate some functions of an AV
source on the map screen.
Route calculation seems to have stopped.
Remedies/Causes
• Adjust the volume to the optimum level.
• Check the cords and connections.
Sunshine from the windshield may cause this symptom.
Adjust the picture. (☞ page 68)
Detach the monitor panel, then attach it. (☞ page 4)
• Keep your hands and the touch panel clean and dry.
• Eliminate static electricity and do not place magnetic
items near the unit.
• Leave the unit until the temperature becomes stable in
the car.
• A rubber mat on the floor may cause this symptom. In
this case, do not use the rubber mat.
Surround noise interferes. Increase the <Adaptive
Volume> level. (☞ page 69)
Reset the calibration data by selecting <Reset
Calibration Data>. (☞ page 39)
The text may not be displayed correctly depending on the
condition of recording or the type of the character, etc.
though 2-byte and 1-byte characters can be displayed on
the unit.
The System cannot start up. Detach the monitor panel,
then attach it. (☞ page 4)
The System proceeds calibration. Wait until calibration is
completed. When calibration is completed, the guidance
starts.
On the map screen, you can operate some limited
functions of the current source only. Press AV MAP and
operate the source on the AV screen.
Route calculation may take long depending on the route.
Wait for a while.
85
Continued on the next page