Samsung SCU-2370 User Manual page 40

setup
CAMERA SETUP (SCU-9080/VAC)
This setup guide is intended for SCU-9080/VAC that may differ depending on the camera module.
Protocol Type (
- This enables you to specify the protocol type of
the camera module. Improper protocol settings
may result in an abnormal operation of the
product.
- SAMSUNG-T: SCB-3000/SHC-745
- SAMSUNG-E: SCB-4000
Lens Type (SCU-VAC)
- FEEDBACK / NON F/B /SLA-12240 /
SLA-880:
Select a model if using a Samsung product
(SLA-12240/SLA-880); select a model that
supports feedback if using a third-party
product.
- Reversed Zoom:
Depending on the wiring direction, Tele/Wide
can be controlled reversely. This is what you
can use to make the product work properly
without changing the wiring. (OFF: Disabled,
ON: Enabled)
- Zoom Tele Pos.(Feedback/SLA-12240 Lens
Specifi cation):
If the feedback value from the motorized zoom
lens increases when you perform the zoom tele, you must set the value to Increase (Default)
so that the zoom factor will be displayed accordingly.
However, if an abnormal zoom factor is displayed, you must set the value to Decrease so that
the zoom factor will be displayed accordingly.
- Reversed Focus :
Depending on the wiring direction, Far/Near can be controlled reversely. This is what you can
use to make the product work properly without changing the wiring.
- Focus Near Pos.(Feedback/SLA-12240 Lens Specifi cation):
If the feedback value from the motorized zoom lens increases when you perform Focus Near,
you must set the value to Increase (Default) so that the Focus function works properly.
However, if the Focus function does not work properly, you must set it to Decrease so that it
works properly.
- Display Zoom (Feedback/SLA-12240 Lens Specifi cation):
Select this if you want to display the value of the zooming position according to the feedback
from the motorized zoom lens. (However, the displayed value is a position value rather than
the zoom factor.)
40_ setup
Main Menu
► Camera Setting
Sequence Setting
P/T Setting
OSD Setting
Alarm Setting
Initialize
Status
Camera Setting
Protocol Type
Lens Type
Open Camera Menu
<SCU-VAC>
Camera Setting
► Open Camera Menu
<SCU-9080 >
SAMSUNG-T
SLA 880