Preparing To Install Forward-Facing - Cosco Apt 40RF Instructions Manual

It maybe easier to tighten the
vehicle belt through the belt
path opening as shown.
With a switchable retractor,
pull the vehicle shoulder belt
all the way out to switch the
retractor into the ALR mode
before tightening. Feed the
slack back into the retractor
while tightening.
6. Check Vehicle belt
Tightness
Grasp the child restraint
at the belt path with one
hand. Push and pull the
child restraint from side
to side, forward and back.
The child restraint should
not move more than 1 inch.
NOTE: If it moves more than
an 1 inch, try reinstalling the
child restraint or try another
seating location.
Secure your child in the
child restraint. Recheck the
recline angle to make sure it
is reclined according to your
child's weight. Repeat steps
if not reclined correctly.
39
F-1 Preparing to Install Forward-Facing
22-40 lbs (10.1-18 kg) and 34-43 in. (85.1-110 cm) and at
least 1 Year Old. Forward-Facing using 5-point harness
LATCH Belt
Lap Belt
Never place a child less than one-year old or
weighing less than 22 lbs. forward-facing.
Safety Tip:
Experts agree that children should remain
rear-facing as long as possible. In this child
restraint, your child can remain rear-facing up
to 40 pounds and up to 40 inches.
40
Meijer.com
Lap/
Shoulder Belt