Cosco Apt 40RF Instructions Manual page 25

Installation Tip:
Loosely attach the top
anchorage hook (tether)
before threading the
vehicle belt. Consult
vehicle's owner manual
for specific location.
NOTE: When not using the
top anchorage strap (tether),
attach the hook to the recline
stand as shown. Tighten
tether to remove the slack.
Thread Vehicle Belt
3.
Thread the vehicle lap or lap/
shoulder belt combination
through the forward-facing
belt slot and out the other
side. Buckle vehicle belt.
4. Tighten Vehicle Belt
Push down firmly on the
child restraint and pull on
the vehicle shoulder belt or
lap belt adjuster to tighten.
47
It maybe easier to tighten
the vehicle belt through the
belt path opening as shown.
With a switchable retractor,
pull the vehicle shoulder
belt all the way out to
switch the retractor into
the ALR mode before
tightening. Feed the slack
back into the retractor
while tightening.
6. Tighten Top
Anchorage Strap
(Tether)
Push firmly on the back
of the child restraint and
tighten top anchorage
strap (tether).
Check Vehicle Belt
7.
Tightness
Grasp the child restraint at
the belt path with one hand.
Push and pull the child
restraint from side to side,
forward and back. The child
restraint should not move
more than 1 inch.
NOTE: If it moves more than
an 1 inch, try reinstalling the
child restraint or try another
seating location.
Secure your child in the
child restraint.
48
Meijer.com