II. Installation and Operating Instructions
A. Checks Before Installation
1.
Remove all shipping cartons, tape and packing. If packing material is left in
the icemaker, it will not work properly.
. Ensure all components, fasteners and thumbscrews are securely in place.
• Remove the panels to prevent damage when installing the icemaker. (See "B. How to
Remove Panels.")
• Remove the package containing the accessories from the compressor compartment.
• Remove the protective plastic film from the panels. If the icemaker is exposed to the
sun or to heat, remove the film after the icemaker cools.
• Check that the refrigerant lines do not rub or touch lines or other surfaces.
• Check that the compressor is snug on all mounting pads.
• See the nameplate on the rear panel, and check that your voltage supplied
corresponds with the voltage specified on the nameplate.
• This icemaker needs a storage bin. The recommended storage bin is HOSHIZAKI ICE
STORAGE BIN, Model B-800 series.
B. How to Remove Panels
See Fig. 1
• Front Panel: Remove the two screws. Lift up and pull
towards you.
• Top Panel: Remove the two screws, and then lift off.
• Side Panel (R): Remove the screw. Pull slightly
towards you, and take off.
• Insulation Panel: Remove the thumbscrew. Lift up
slightly, and pull towards you.
IMPORTANT
13
Fig. 1