3. Tip: Loosen the four M6 x 38mm Screws (25)
if the Backrest Tubes (52) do not slide into
the Seat Carriage (41).
Insert the Backrest Tubes (52) into the Seat
Carriage (41).
Attach each Backrest Tube (52) with an M8
x 35mm Bolt (72), an M8 Split Washer (93),
and an M8 Locknut (90). Make sure that the
Locknuts are in the hexagonal holes in the
Seat Carriage. Do not tighten the Bolts yet.
4. Tip: Avoid damaging the wires inside the
Seat Handlebar (11) during this step.
Attach the Seat Handlebar (11) to the Seat
Carriage (41) with two M8 x 68mm Bolts (70),
two M8 Curved Washers (86), and two M8
Locknuts (90). Make sure that the Locknuts
are in the hexagonal holes in the Seat
Carriage.
Then, plug the pulse wire (A) into the receptacle
in the Right Shield (14).
See step 3. Tighten the two M8 x 35mm
Bolts (72).
3
25
52
93
72
93
4
11
41
86
70
A
7
25
52
41
90
90
90
90
14