Audio Setup; Speaker Setting - Kenwood KDC-X592 Instruction Manual

Audio Adjustments
Audio Setup
You can set Sound system, such as follows;
Speaker Setting
Fine-tuning so that the System Q value is optimal
when setting the speaker type as follows;
Rear High Pass Filter "HPF-R"
Low Pass Filter "LPF"
: _ -
OFF "OFF"
.....:.-_--------
For 5 & 4in. speaker "S/4inch"
....::.:....=.:..-_------
For 6&6x9 in. speaker "6x9/6inch"
- - - - - - - - - -
For the OEM speaker "O.E.M."
Subwoofer Phase
Volume offset
Loudness
Dual Zone System
*1
KDC-X592 only.
~
~
• Volume offset: Sets each source's volume as a difference
from the basic volume.
• Loudness: Compensates for low and high tones during
low volume. (Only the low tone is compensated for
when the tuner is selected as a source.)
• Dual Zone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
- Set up the channel of sub source by "Zone2" of
<Function Control> (page 6).
- Select Main source by [SRC] button.
- Adjust the volume of Front channel by [AUD] knob.
- Adjust the volume of Rear channel by <Audio Control>
(page 15) or
[A]/(''']
button on the remote control
(page 20).
- The Audio Control has no effect on sub source.
1
Select the source to adjust
For how to select source item, refer to <Power/
Source Select button> of <Basic Operation> (page
4).
2
Enter Audio Setup mode
Press the [AUD] knob for at least 1 second.
3
Select the Audio Setup item to adjust
Press the [AUD] knob.
4
Adjust the Audio setup item
Turn the [AUD] knob.
S
Exit Audio Setup mode
Press the [AUD] knob for at least 1 second.
16
I KDC-X592/ KDC-MP538U
1
Enter Standby
Select the "STANDBY" display.
For how to select source item, refer to <Power/
Source Select button> of <Basic Operation> (page
4).
2
Enter Speaker Setting mode
Press the [AUD] knob.
"SP SEL' is displayed.
3
Select the Speaker type
Turn the [AUD] knob.
4
Exit Speaker Setting mode
Press the [AUD] knob.