Re-Installing Covers - Viessmann Vitodens 100-W WB1B Series Installation And Service Instructions Manual

Vitodens 100-W, WB1B Installation & Service

Re-installing Covers

1.
2.
3.
5.
4.
A
6.
Reinstalling the covers for the boiler, power pump module
and the CombiPLUS A.
1. Align and install the cover of the power pump module
and lock into place by rotating the four captive screws
90 degrees with a Phillips screw driver.
2. Rotate the boiler controls up and in.
Ensure that the locking clips are engaged.
3. Install the boiler cover by inserting it straight on from
the front.
4. Tighten the boiler housing captive screws (located
at the bottom front of the boiler).
5. Install the CombiPLUS A cover by inserting it
straight on from the front.
6. Using a Phillips screw driver, install and tighten all
four screws holding the CombiPLUS A cover.
Legend
A CombiPLUS
Connections
33