Brother P-touch 9400 User Manual page 25

Ch. 2 Getting Started
On a Macintosh computer:
Follow the procedure below to install the P-
touch Editor software on the Mac.
NOTE
Only the US English version of the P-touch Editor
software for the Mac is available.
1 Check that your system configuration meets
the following requirements.
Computer: Macintosh or Power Macintosh
Hard disk free space: At least 20 MB
NOTE
A few hundred megabytes of additional free space
may be needed when printing long labels or large
amounts of data.
Operating system: System 7.5.3 or later
Printer port: 8-pin connector jack
CD-ROM drive
2 Connect the PT-9400 to the computer's
printer port and turn both of them on.
3 Insert the P-touch Editor CD-ROM into the
computer's CD-ROM drive and double-
click the CD-ROM icon.
NOTE
The installers for the P-touch Editor programme and
the User's Guide can also be copied from the CD-
ROM onto floppy disks. Refer to the Readme file for
more details.
4 Open the "PT-9200PC" folder, and then dou-
ble-click the "P-touch Editor 3.0 Installer"
icon.
5 Click either the Install button (installs all
options) or the Custom Install button (allows
you to select which options to install).
16
NOTE
If you clicked the Custom Install button, the dialogue
box shown below is displayed allowing you to select
which options will be installed.
After selecting the desired options, click the Install
button to install the selected options.
6 In the dialogue box that appears when
installation is completed, click the Quit but-
ton. A dialogue box which allows you to
restart your computer appears.
7 Click the Restart button.