Laminated Tape; Non-Laminated Tape; Instant-Lettering Tape - Brother P-touch 9400 User Manual

Table of Contents

Ch. 4 Using Labels and Stamps

Laminated tape

The backing from labels printed on laminated

tapes can easily be removed if a half cut setting

was used (refer to page 70). However, if a half

cut setting was not used, the backing paper can

be removed by using the enclosed lettering

stick.

1 Hold the tape in your left hand, with the

printed surface facing up, and hold the let-

tering stick in your right hand.

2 Pass the tape halfway through the long nar-

row hole in the stick.

3 Turn the stick three quarters of a turn

towards you and pull the stick away from

you as shown below.

4 Peel off the label backing.

5 Slightly fold labels printed on non-lami-

nated tape in half so that the inside edges of

the two backing pieces come off the label,

enabling them to be peeled off easily.

By printing your text on instant-lettering tape

(rub-on transfers), you can transfer the text

directly onto a sheet of paper.

1 Place the label with its printed side facing

down on the paper.

2 Rub the label's non-printed side with the

enclosed lettering stick.

NOTE

Hold the label very firmly so that it does not

move while you transfer the text.

Table of Contents