Sanitizing Procedure - Icemaker - Hoshizaki DKM-500BAH Service Manual

15) Turn off the power supply after 30 minutes.
16) Remove the front panel.
17) Move the service switch to the DRAIN position.
18) Replace the front panel in its correct position.
19) Turn on the power supply for 2 minutes.
20) Turn off the power supply.
21) Remove the front panel.
22) Move the control switch to the ICE position.
23) Replace the front panel in its correct position.
24) Turn on the power supply to fill the water tank with water.
25) Turn off the power supply after 3 minutes.
26) Remove the front panel.
27) Move the control switch to the SERVICE position. Then move the service switch to the
WASH position.
28) Replace the front panel in its correct position.
29) Turn on the power supply to rinse off the cleaning solution.
30) Turn off the power supply after 5 minutes.
31) Remove the front panel.
32) Move the service switch to the DRAIN position.
33) Replace the front panel in its correct position.
34) Turn on the power supply for 2 minutes.
35) Turn off the power supply.
36) Remove the front panel.
37) Repeat the above steps 22 through 36 three more times to rinse thoroughly, then
proceed to "2. Sanitizing Procedure – Icemaker".
2. Sanitizing Procedure – Icemaker
1) Dilute approximately 1.0 fl. oz. of a 5.25% sodium hypochlorite solution (chlorine
bleach) with 2 gallons of warm water.
2) Pour the sanitizing solution into the water tank.
3) Move the service switch to the WASH position.
4) Replace the front panel in its correct position.
5) Turn on the power supply, and start the sanitizing process.
6) Turn off the power supply after 15 minutes.
7) Remove the front panel.
8) Move the service switch to the DRAIN position.
9) Replace the front panel in its correct position.
43