Hoshizaki DKM-500BAH Instruction Manual
Hoshizaki DKM-500BAH Instruction Manual

Hoshizaki DKM-500BAH Instruction Manual

Crescent cube icemaker / dispenser
Hide thumbs Also See for DKM-500BAH:

Advertisement

Hoshizaki
Hoshizaki America, Inc.
"A Superior Degree
of Reliability"
www.hoshizaki.com
Crescent Cube Icemaker / Dispenser
Models
DKM-500BAH
DKM-500BWH
INSTRUCTION MANUAL
Issued: 3-24-2006
Revised: 1-28-2008

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DKM-500BAH and is the answer not in the manual?

Questions and answers

Summary of Contents for Hoshizaki DKM-500BAH

  • Page 1 Hoshizaki America, Inc. “A Superior Degree of Reliability” www.hoshizaki.com Crescent Cube Icemaker / Dispenser Models DKM-500BAH DKM-500BWH INSTRUCTION MANUAL ™ Issued: 3-24-2006 Revised: 1-28-2008...
  • Page 2 Should the reader have any questions or concerns which have not been satisfactorily addressed, please call, write, or send an e-mail message to the HOSHIZAKI Technical Support Department for assistance. HOSHIZAKI AMERICA, INC.
  • Page 3: Table Of Contents

    Please retain this booklet for any further reference that may be necessary. I. Specifications ... 4 A. Nameplate Rating ... 4 1. DKM-500BAH ... 4 . DKM-500BWH ... 5 B. Dimensions/Connections ... 6 1. DKM-500BAH ... 6 .
  • Page 4: Specifications

    I. Specifications A. Nameplate Rating 1. DKM-500BAH HOSHIZAKI ICE MAKER MODEL NUMBER SERIAL NUMBER AC SUPPLY VOLTAGE AMPERES DESIGN PRESSURE REFRIGERANT MOTOR-COMPRESSOR THERMALLY PROTECTED, NOT INTENDED FOR OUTDOOR USE! ICE MAKER 946Z See the nameplate for electrical and refrigeration specifications. This nameplate is located on the rear panel.
  • Page 5: Dkm-500Bwh

    2. DKM-500BWH HOSHIZAKI ICE MAKER MODEL NUMBER SERIAL NUMBER AC SUPPLY VOLTAGE AMPERES DESIGN PRESSURE REFRIGERANT MOTOR-COMPRESSOR THERMALLY PROTECTED, NOT INTENDED FOR OUTDOOR USE! ICE MAKER 946Z See the nameplate for electrical and refrigeration specifications. This nameplate is located on the rear panel.
  • Page 6: Dimensions/Connections

    B. Dimensions/Connections 1. DKM-500BAH...
  • Page 7: Dkm-500Bwh

    2. DKM-500BWH...
  • Page 8: Installation And Operating Instructions

    II. Installation and Operating Instructions A. Checks Before Installation 1. Install in accordance with all applicable national, state, and local regulations. . Remove the shipping carton, tape, and packing material. If any are left in the icemaker, it will not work properly. 3.
  • Page 9: Setup

    C. Setup 1) Remove the front panel to avoid damaging it during setup. To remove the panel, remove the screw, lift up and slightly towards you. Disconnect the connector from the control box. Although not generally necessary for installation, if you need to remove other panels, see "II.H.
  • Page 10: Water Supply And Drain Connections

    E. Water Supply and Drain Connections See Fig. 2 To prevent damage to equipment, do not operate the icemaker when the water supply is off, or if the pressure is below 10 PSIG. Do not run the icemaker until the proper water pressure is reached. •...
  • Page 11 DKM-500BAH Icemaker Water Supply Inlet 1/2" FPT Icemaker Drain Outlet 3/4" FPT Storage Bin Drain Outlet 3/4" FPT DKM-500BWH Icemaker Water Supply Inlet 1/2" FPT Icemaker Drain Outlet 3/4" FPT Condenser Water Supply Inlet 1/2" FPT Condenser Drain Outlet 3/8" FPT...
  • Page 12: Final Checklist

    F. Final Checklist 1) Is the icemaker level? ) Is the icemaker in a site where the ambient temperature is within +45°F to +100°F (+7°C to +38°C) and the water temperature within +45°F to +90°F (+7°C to +3°C) all year around? 3) On air-cooled model, is there at least 1"...
  • Page 13: Startup

    G. Startup 1. All parts are factory-adjusted. Improper adjustments may result in failure. . If the unit is turned off, wait for at least 3 minutes before restarting the icemaker to prevent damage to the compressor. 3. To prevent damage to the water pump, do not leave the control switch in the "SERVICE"...
  • Page 14: How To Remove Panels

    H. How to Remove Panels See Fig. 4 • Front Panel: Remove the screw, lift up and slightly towards you. Disconnect the connector from the control box. • Top Panel: Lift up at front slightly, push rearward, and lift off. •...
  • Page 15: Cleaning And Maintenance

    "SERVICE" position for extended periods of time when the water tank is empty. 1. Cleaning Procedure – Icemaker 1) Dilute 10.5 fl. oz. (311 ml) of recommended cleaner Hoshizaki "Scale Away" or "LIME-A-WAY," (Economics Laboratory, Inc.) with  gal. (7.6 l) of warm water. ) Remove all ice from the evaporator.
  • Page 16: Sanitizing Procedure - Icemaker

    5) Move the service switch on the control box to the "DRAIN" position. Then move the control switch to the "SERVICE" position. 6) Replace the front panel in its correct position and allow the icemaker to drain for  minutes. 7) Remove the front panel and move the control switch to the "OFF"...
  • Page 17: Cleaning Procedure - Storage Bin

    Proceed to "3. Cleaning Procedure – Storage Bin". 3. Cleaning Procedure – Storage Bin 1) Dilute 5 fl. oz. (148 ml) of recommended cleaner Hoshizaki "Scale Away" or "LIME-A-WAY," (Economics Laboratory, Inc.) with 1 gal. (3.8 l) of warm water.
  • Page 18: Maintenance Instructions

    B. Maintenance Instructions 1. Icemaker and Storage Bin • Hoshizaki recommends cleaning this icemaker at least once a year. More frequent cleaning, however, may be required in some existing water conditions. • The storage bin is for ice use only. Do not store anything else in the storage bin.
  • Page 19 5) Dispense all of the ice from the storage bin. 6) Attach a compressed air or carbon dioxide supply to the icemaker water supply line drain valve. 7) Make sure at least 3 minutes have elapsed since you moved the control switch to the "SERVICE"...
  • Page 20 HOSHIZAKI AMERICA, INC. 618 Hwy. 74 S., Peachtree City, GA 30269 USA TEL (770) 487-2331 FAX (770) 487-3360 www.hoshizaki.com 91A4QA10B...

This manual is also suitable for:

Dkm-500bwh

Table of Contents